The Roblox experience page, on its October 3, 2026 update listing, shows an Autumn Event as live. The written route below is the November 1, 2025 maze that was added inside the Flying Island. Use it as the last full walkthrough, then abandon any step the live island no longer has.
The 2025 update page says six new blocks were added and names the Laser, Resistance Block, Pumpkin, and Pumpkin Balloon. It does not name the other two. Halloween-styled pumpkin and balloon versions lasted one day. The normal versions came after that.
Get to the maze
The Flying Island is the floating island with four large propeller pods, a central pine, a house, and a bunker. Fly there from your plot. The propellers destroy vehicles that touch them. Enter the maze through the open hatch or bunker, or through the runway built into the side of the island. A map of that maze marks Entrance, Elevators, Pumpkins, Pumpkin Balloons, Resistance Block, and decorative Eggs. The map is not to scale.
Community pages disagree on the island's height. The April 2026 island article says altitude 600. An older description said about 550 studs. Either way it is a high, stationary island, not a second plot.
Laser block
- Search the maze for three picture frames. The frame shows a picture and a name underneath. Scary Pumpkin and Scary Balloon frames do not count.
- The three-frame combination changes from server to server. Do not copy a code from another server.
- At the elevator room, step on the pressure plate to get inside.
- Try the three combinations. If nothing happens, the plate may already have been used. Wait until the plates rise, then try again.
- A working combination makes the elevator say UNLOCKED and opens the door. Use the elevator button.
- Skip the first two upper entrances. They are traps. Take the last entrance.
- Dodge the lasers, reach the console, and pull the red lever. That disables the lasers.
- Touch the Laser block in the middle of the room. That grants the block.
Resistance Block
- Return to the elevator room in the same maze and step on the pressure plate so the room door opens.
- Outside the elevator, to the left of the pillar, press the small stone button.
- The Resistance Block door opens. The block is also marked on the maze map.
The Resistance Block resists motion on its own X, Y, and Z axes, not the world axes. X is left-right, Y is up-down, and Z is forward-back relative to the part. Each drag slider defaults to 5 and runs from -20 to 20. Toggle defaults to H. Powered defaults to on. The part limit on its page is 500. It was introduced with this autumn update.
Pumpkins and pumpkin balloons are marked as block locations on the same map. Eggs are marked as decoration only.
If the October 2026 event uses a different island layout, stop at the first missing door. Do not force the 2025 lever sequence on a room that is not there.